The Hilton Airflow System F100 and its expandable range of optional accessories enable students to safely investigate the fundamentals of airflow and simple aerodynamic experimental procedures. The unit consists of a small footprint, high volume high pressure centrifugal fan with adjustable flow control, inlet and outlet couplings. The Hilton Airflow System F100 is available with an extensive range of optional accessories that makes the unit a very flexible and economic investment. The extensive range of optional accessories allow investigation of Bernoulli’s equation, drag forces on various shapes, Investigation of a turbulent jet, investigation of boundary layer development, pressure distribution of flow around a bend, fan performance characteristics, jet attachment, pressure distribution around a cylinder, pressure distribution around an aerofoil, flow visualisation studies, air flow measurement methods.

The complete range is safe and suitable for unsupervised student operation and responds immediately to system changes allowing efficient use of laboratory time.

F100 Airflow System Base Unit

The Hilton Airflow System F100 and its range of optional accessories enable students to safely investigate the fundamentals of airflow and simple aerodynamic experimental procedures.

HB100 Hydraulics Bench

The hydraulics bench is mounted on lockable castor wheels and is constructed around a sturdy framework onto which all elements of the hydraulics bench are mounted. The main water storage tank from which the electrically operated external pump takes its water is situated on the framework. An on/off control on the front of the frame, together with a safety cut out controls the pump.

F100A Multi-Tube Manometer

A multi-tube manometer with a common reservoir, that may be used to give a graphic display of pressure distribution on multi-point pressure tapings.

F100B Bernoulli's Equation

A convergent divergent duct section that connects to the Hilton Airflow System F100 using a flexible coupling.

F100C Boundary Layer Investigation

A reversible flat plate located inside a rectangular duct. The plate has one smooth and one artificially roughened face. The duct has removable profile plates that can establish an increasing or decreasing pressure gradient in the direction of flow.

F100D Round Turbulent Jet Investigation

A round parallel tube with a sharp edged discharge is used to create a turbulent jet using the air from the Air flow System F100.

F100E Flow Round a Bend Investigation

A 90 degree bend of constant cross section has air blown through it from the Airflow System F100. Along the inner and outer radius at strategic points, static pressure tapping points are located.

F100F Jet Attachment Investigation

A rectangular slit directs an air jet towards a Y shaped duct with two outlet passages.

The shape of the duct may be changed by tilting and sliding moveable elements to allow students to investigate the Coanda effect of jet attachment to a wall.

By blowing air from one side or another at the jet, the airflow can be directed down either of the Y shaped passages as in a pneumatic flip-flop.

F100G Drag Force Investigation

A short duct with integral load balance allows the drag of a body to be directly measured at a range of  approach velocities.

The bodies include an aerofoil, cylinder and plate.

The cylinder has a radial tapping to allow investigation of the pressure distribution around the cylinder.

F100H Flow Visualisation Investigation

A smoke generator generates a visual oil mist that is introduced into the airstream ahead of the test shape through a number of fine nozzles.

The resulting smoke filaments clearly show streamlines around the test shapes. 

Products per page:

Back to top